|Kakute F7 HDV Flight Controller|
MCU: STM32F745 32-bit processor
USB VCP Driver (all UARTs usable simultaneously; USB does not take up a UART)
6 hardware UARTS (UART1,2,3,4,6,7)
All UARTS support hardware inversion. SBUS, SmartPort, and other inverted protocols work on
any UART without “uninvert hack”.
Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only. PPM and PWM receivers are not
TF card for Blackbox logging
Mounting Holes: Standard 30.5mm square to center of holes
|Tekko32 F3 HDV 45A ESC|
HDV 45A ESC
32bit ESC with BLHELI32 firmware
Supports 3-6S lipo input
PWM input, TLM supported
Voltage output (VBAT)
Supports oneshot / Multishot / Dshot PWM
Mounting holes 30.5×30.5mm
Supports damped light
F3 MCU, runs double faster than F051
Extra Cap needed for high current or 6s usage
The latest tekko32 45A 4in1 ESC has got some improvements on its performance：
1) Enhanced BEC, withstand voltage up to 80V.
2)The first blheli32 ESC in the market with default PWM output 96K giving you smoother and quieter experience.
3) Amperage meter scale ratio has been adjusted to 185-195.
4) The mounting hole has been changed into M4 with anti-vibration silicone grommet Insert.
5)The PCB design uses a design in which the drive circuit and the control circuit are separated.
This design broadens the overcurrent capability of the drive circuit, and at the same time reduces the electrical interference to the control circuit.
1 x KAKUTE F7 HDV&Tekko32F3 4in1 45A ESC STACK
1 x Electrolytic capacito: 1000uF 35v
1 x 8pin to 8pin 1mm pitch 65mm cable
1 x 8pin to 8pin 1mm pitch 25mm cable
1 x JST GHR 8pin to JST GHR 6pin 80mm cable ( The cable that goes to the DJI Air Unit is included.)
1 x JST GHR 8pin to JST GHR 6pin 150mm cable ( The cable that goes to the DJI Air Unit is included.)